Practical Networking for broadcast engineers
IP networks now sit underneath almost everything in a broadcast facility. Engineers who have only ever used a network struggle when one misbehaves, because they have never watched a switch or a router handle packets from the inside.
This course is for broadcast engineers who know the theory and now need to build real networks. Every delegate builds their own network from factory-reset equipment, following worksheets they keep.
What you will be able to do
- Take a MikroTik router from factory reset to a working LAN with DHCP, DNS, NTP and WiFi, and a WAN connection with NAT and a firewall
- Configure an Arista or Cisco switch from the console: VLANs, access ports, routed interfaces, DHCP servers and inter-VLAN routing
- Build a Layer 3 link between the switch and the router, add the static routes, and prove it end to end
- Back up, restore and reset both platforms
- Read a running configuration and recognise what is missing or wrong
- Describe a network or a fault in terms a specialist support team will recognise
Day by day
Day 1: revision of networks, Ethernet and IP
- Networks and the layered model
- Layer 2: frames, MAC addresses, how a switch learns and forwards, VLANs, access and trunk ports
- Layer 3: addresses, subnets and CIDR notation, routers and routing tables, routing protocols in outline, NAT
Day 2: MikroTik, building a router from scratch
- RouterOS and its tools: WinBox, WebFig and the terminal. Backup, restore and factory reset
- The default configuration read as a block diagram, then wiped
- Rebuilding it by hand, one service at a time: LAN bridge, DHCP, DNS and NTP, WAN, NAT, firewall rules, and WiFi
- Further exercises for early finishers
Day 3: Arista or Cisco, configuring a Layer 3 switch
- The console, the command line and its modes, and saving and backing up a configuration
- From the default configuration: named VLANs, access ports, routed interfaces with IP addresses, DHCP servers, and inter-VLAN routing
- Joining the two builds with a Layer 3 link from the switch to the MikroTik over an SFP, with static routes each way
- If time permits: PTP on the switch as a boundary clock, confirmed in Wireshark
How it runs
- Three days, for up to six delegates, each at their own desk of equipment
- Per delegate: a MikroTik router, an enterprise switch and a Windows laptop. Day 3 is taught on Arista or Cisco, whichever you use. I can bring the MikroTiks and the Arista or Cisco switches, or use your own. Laptops are best provided by you
- Prerequisite: Network Fundamentals or equivalent. You should already know what a MAC address, an IP address, a subnet mask, a switch and a router are
- A good preparation for the AoIP course, which has this course as a prerequisite
Network Fundamentals
A one-day classroom course, with no limit on numbers and no practical work. It teaches the theory that Practical Networking assumes: what a MAC address, an IP address, a subnet mask, a switch and a router are, and how they work together.